Zebra RW SERIES Specifikace stáhnout pdf (Strana 77)

• 2-77 • RMAN-RWS-001 rev. B • RW Series Repair Procedures

2. Install the (2) Springs, Printhead supplied with the repair kit to the Bar, Spring.

3. Re-assemble the Bar, Spring to the Printer Frame. Ensure that the Printhead

Springs are seated over the heads of the screws securing the tear bar to the

printhead

4 Plug in the Printhead, Bar Sensor and the Gap Sensor Cable to the CPU Board

per the table below. If you unplugged the Motor cable, plug it into J6 at this

time.

CPU CONNECTIONS

CABLE CPU CONNECTOR

MOTOR CABLE J6

BAR SENSOR FLEX CABLE J2

GAP SENSOR FLEX CABLE J10

PRINTHEAD CABLE J5

5. Re-secure the CPU Board. Refer to Procedure RK17949-014 for more details.

6. Install the Upper Housing Assembly. Refer to Procedure RK17949-008/-009 for

more details. Also ensure you have re-installed the D-Rings between the Upper

and Lower Housings.

7. Install the Battery Pack and media and perform a two-key reset to verify that

the Printhead has been properly installed.

8. Perform the Unit Test procedure. Perform a complete unit test to ensure that

the sensor calibrations are still correct.

 Thetestprocedurecanonlybeperformedbycertiedpersonnelusingspecial

equipment and software.

Bar, Spring

Replacement Printhead

Springs (2)

p/n BA17932-1

(Included with RK17949-005)

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 113 114

Žádné komentáře

Zebra RW SERIES Specifikace Strana 77