Zebra RW SERIES Specifikace stáhnout pdf (Strana 62)

RMAN-RWS-001 rev. B • RW Series Repair Procedures • 2-62 •

4. Remove the PCB and the Lower Plate from the Upper housing assembly.

Install the PCB in the replacement Housing

1. Plug the Flex Circuit from the Upper Housing into the PCB.

2. Secure the PCB to the Upper Housing of the Vehicle Cradle with (5) Screws

retained in the previous step..

3. Plug the Flex Circuit from the Upper Housing into the PCB.

4. Plug the power cable into the PCB

Install the Base Plate

1. Secure the Plate, RW4 Cradle RAM Mount to the Upper Housing with the (7)

screws retained from the rst step.

Finish the Installation

1. Re-secure any cable clamps you removed during the disassembly procedure.

Ensure the power cable is routed correctly for your installation.

2. If you removed a communications cable from the Cradle, reinstall it.

3. If the Cradle was attached to either an optional RAM Mount or to a vehicle, re-

secure it with the retained hardware.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 113 114

Žádné komentáře

Zebra RW SERIES Specifikace Strana 62