Zebra TTP7030 Specifikace stáhnout pdf (Strana 56)

Programming

Cut And Present Commands

P1003636-001 TTP 7020™/TTP 7030™ Technical Manual 02/11/2009

ESC FF ejects the document through the presenter module. Variable n represents the number

of eject-steps.

One step is approximately 2 mm

The maximum number of steps is 255

Normally, this command is placed after a cut command (ESC RS) to partially eject the

printout to the customer. Set the number of eject steps so that a good portion of the printout is

retained in the presenter module, avoiding that the printout drops to the floor.

Another use of the command is to eject a part of a long document without preceding cut. The

reason to do this is to limit the size of the loop build-up in the presenter.

Same function as ENQ but overrides the Retract and Retain parameter (p45) with another

presenter behavior. The function of n can be 0 to 255 0-99 ejects while 100-255 retracts (see

the description of parameter 45). The command will clear the presenter immediately (with

printing synchronization).

ESC FF n1

Eject (run presenter)

1B 0C n1 hex

27 12 n1 decimal

Note • The loop is limited to the value set by ESC f n to avoid paper jam. The default

setting of n=18, gives a loop of just above 0.5 m. When this length has been looped, the

printer presents that part of the printout. Then, without cutting the paper, it continues to print

the rest of the printout.

Figure 20 • Approximate Settings For Different Eject

Feed, cm n1 Feed, cm n1 Feed, cm n1 Feed, cm n1 Feed, cm n1

1 6 6 36115516692182

2 15 7 40 12 58 17 71 22 85

3 21 8 43 13 62 18 73 23 88

4 27 9 48 14 65 19 76 24 92

5 331052156720792595

Enforced Clear Presenter

19 n1 Hex

25 n1 Decimal

<EM><000> Ejects the presented page

<EM><100> Retracts the presented page

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 143 144

Žádné komentáře

Zebra TTP7030 Specifikace Strana 56