Zebra Eltron Card Printer Uživatelská příručka stáhnout pdf (Strana 80)

5.2.16 Encoder Head Replacement

Two Encoder Head configurations exist—the standard below-the-card-path

configuration and the above-the-card-path configuration.

For Common Requirements:

Step 1. Remove the Rear Case (see Section 5.2.1).

Step 2. Remove the Encoder Station Shroud (see Figure 5-22).

For Above-the-Card-Path Configurations (Figure5-23):

Step 1. Unplug the Encoder Head Connector from the Encoder Board, and Remove

the Rear Plate (see Sections 5.2.10 and 5.2.11).

Step 2. Remove the two screws holding the Encoder Head, and while feeding the

cable along the routing path, remove the Encoder Head.

5-24 980264-001 Rev.B

CHAPTER 5

Figure 5-22. Encoder Station Shroud.

Figure 5-23. Encoder Head (Above-the-Card-Path).

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 111 112

Žádné komentáře

Zebra Eltron Card Printer Uživatelská příručka Strana 80