Zebra Eltron Card Printer Uživatelská příručka Strana 77

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 112
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 76
5.2.15 Smart Card Interface Board Replacement (Option)
Units equipped for Smart Card Docking have the following components:
Smart Card Interface PWB
Smart Card Solenoid
Smart Card Contact Station
For Smart Card Interface removal, refer to Figure 5-19, and proceed as follows:
Step 1. Detach the Rear Case member (see Section 5.2.1).
Step 2. Disconnect the connectors to the Solenoid, CPU Board, and Contact Station.
Step 3. Remove the two DB-9 fasteners and the PWB. Note that excessive torque on
these fasteners during installation of a new PWB can produce damage. Try to
duplicate the torque required for removal when installing a new board.
980264-001 Rev. B 5-21
CHAPTER 5
Figure 5-19. Smart Card PWB
Zobrazit stránku 76
1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 111 112

Komentáře k této Příručce

Žádné komentáře