Zebra Eltron Card Printer Uživatelská příručka Strana 100

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 112
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 99
Step 4. Adjust the Brightness Adjustment Screw by either loosening or tightening.
Remember the amount and direction of adjustment. If loosening, push the Head
Assembly until the adjustment screw again bears against the Print Head Yoke.
Step 5. Tighten the Head Fasteners in the sequence shown.
Step 6. Print another Test Card. Then compare the cards. Any improvement in
brightness signals a proper direction of adjustment. Conversely, any deterioration
in brightness indicates that the adjustment should have been in the opposite
direction or possibly that too great an adjustment placed the Print Head beyond
the optimum point.
Step 7. Repeat Steps three through six until an optimum brightness is achieved.
6-10 980264-001 Rev.B
CHAPTER 6
Figure 6-8. Image Brightness Adjustment.
Zobrazit stránku 99
1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 111 112

Komentáře k této Příručce

Žádné komentáře