Zebra Eltron Card Printer Uživatelská příručka Strana 101

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 112
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 100
For an adjustment to make the Print Head parallel to the Platen Roller, continue as follows:
Step 8. Unlatch and raise the Print Head.
Step 9. Slightly loosen the Print Head fasteners shown in Figure 6-9. However, try to
maintain a tightness just sufficient to leave the Print Head position undisturbed.
Step 10. Examine the last Test Card printed to determine which side has a reduced
brightness. Then, slightly lower the corresponding side of the Print Head, and
tighten the screws.
Step 11. Perform a Peel Bar adjustment (see Section 6.3.4).
Step 12. Latch down the Print Head, and print another Test Card, Note the result of
the repositioning.
Step 13. Repeate Steps eight through 12 until a proper result is achieved.
980264-001 Rev. B 6-11
CHAPTER 6
Figure 6-9. Lower Print Head Fasteners.
Zobrazit stránku 100
1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 111 112

Komentáře k této Příručce

Žádné komentáře