Zebra TTPM3 Specifikace stáhnout pdf (Strana 45)

Programming

Command Reference

01/06/2009 TTPM3 Installation and Programming Manual P1003642-001

TTPM3 has two feed motors, one for encoding and one for printing. This command sets the

start-frequency and the top speed of each motor.

Syntax for defining and downloading graphics data is as follows:

!F A N <start freq> <top speed> <motor> 1 1 1_”remark”

!F A N

Feed- acceleration and speed

21 46 20 41 Hex

33 70 32 65 Decimal

Note • This command should not be used! Suitable speed is selected by Zebra and set as

default parameters in the firmware. The speed setting has to reflect the motors fitted in the

printer and the mechanical buildup of the printer. A single unit may be tunable to a higher

speed but it is not certain that the settings work on the next printer.

Note • Power off/on will set the values to factory default.

!F Command to load print-parameter information.

A Indicates acceleration and speed mode.

N Print orientation. This is ignored in acceleration and speed mode.

Orientation is always North (N). The printer requires the N to be inserted.

<start freq> Start frequency. Set the base frequency from where the acceleration starts. A

value of 30 indicates a start frequency of 300 Hz.

Top speed Top speed is the frequency at which the acceleration stops. A value of 450

sets top speed to 4500 Hz.

motor “1” selects encoding motor, while “2” selects print motor

1 Not used. Must be set to 1.

1 Not used for graphics printing. Must be set to 1.

space One space has to follow the "1" before the graphics data.

Remark Here you can enter a remark describing the setting you just did. It will not be

printed.

Example •

!C<CR><LF>

!F A N 30 250 1 1 1 1 "Encode speed (full-step)"<CR><LF>

!F A N 30 190 2 1 1 1 "Print speed (half-step)"<CR><LF>

!P<CR><LF>

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 111 112

Žádné komentáře

Zebra TTPM3 Specifikace Strana 45