Zebra ZebraNet Uživatelská příručka stáhnout pdf (Strana 43)

Getting Started

Assigning an IP Address

08/27/2007 ZebraNet

10/100 Internal Print Server 14197L-002 Rev. A

for ZM400, ZM600, GK420 and GX420/430 User Guide

Assigning an IP Address

Before you can begin working with 10/100 Internal PS, you must get or assign an IP address

for the 10/100 Internal PS device.

There are four different ways to assign an IP address. Here is a list and a brief description of

each method:

• Web View — Browser-enabled method to assign an IP address.

• ZebraNet View — Utility that remotely manages ZebraLink-enabled printers.

• DHCP — See your LAN administrator for more information.

• Telnet — DOS command to assign an IP address.

With Dynamic Host Configuration Protocol (DHCP)

If your network uses DHCP, your 10/100 Internal PS device is assigned a temporary IP

address.

Without DHCP

If your network does not use a dynamic IP addressing system (such as DHCP), you need to set

a permanent IP address for the 10/100 Internal PS device. ZebraNet View is the

Windows-based print server management and configuration utility that comes with your

10/100 Internal PS.

Important • Throughout the procedures in this chapter, there are some features that require the

default User ID and/or default password. If you are prompted, these are the defaults:

• User ID: admin

• Password: 1234

Note • Check with your Network Administrator to see whether your network uses DHCP.

Important • The remaining sections are dependent on the successful installation of ZebraNet

Utilities. To install, see ZebraNet Utilities on page 50.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 135 136

Žádné komentáře

Zebra ZebraNet Uživatelská příručka Strana 43