Zebra LP 2824-Z Uživatelský manuál stáhnout pdf (Strana 8)

Contact ImproMed® with any questions. www.impromed.com E-mail: [email protected] Phone: (800) 925-7171

8Installation of the LP2824 Plus Printer

19. Select the ZDesigner LP 2824 Plus from the listing.

20. Click Configure Printer Connectivity.

21. Select Wired.

22. Click Next.

23. Select Internal Print Server (print server is inside the printer).

24. Click Next.

25. Select Static.

26. Enter the Printer’s IP address, Subnet Mask, Default Gateway. See ImproMed®’s recommendations

below:

a. IP Address = 192.168.0.230

b. Subnet Mask = 255.255.255.0

c. Default Gateway = 192.168.0.100

Note: If the printer is not accepting the changes, please reset the printer to defaults. If assistance is needed to complete

this, please contact ImproMed’s Customer Support Center.

27. Click Next | Next.

28. Select Printer.

29. Click Finish.

30. From the printer, press the Feed button (Green button) until the light (beneath the button)

flashes once. Then release the button and Printer Configuration pages should print. This could

print up to 3 labels.

31. From the workstation, click Install New Printer.

32. Click Next.

33. Select ZDesigner LP 2824 Plus (ZPL).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Žádné komentáře

Zebra LP 2824-Z Uživatelský manuál Strana 8