Zebra Z6M Specifikace stáhnout pdf (Strana 101)

77259L Rev. 4 12/16/03 Z4M/Z6M Maintenance Manual Page 4-41

3UHYHQWLYHDQG&RUUHFWLYH0DLQWHQDQFH 6HFWLRQ

Figure 4-32. Dancer Assembly

,QVWDOOLQJWKH'DQFHU$VVHPEO\

1. Install the new torsion spring, the first bearing, the dancer, the second bearing, and

then the e-ring.

2. Place the dancer assembly torsion spring back to its operating position against the

printer post and dancer tab. Check to make sure there is tension on the dancer

assembly.

3. Reload the media and ribbon. Close the media door and reconnect power to the

printer.

4. Turn the printer On (l) and print a configuration label.

5LEERQ+HDG2SHQ6HQVRU5HSODFHPHQW

5HPRYLQJWKH5LEERQ+HDG2SHQ6HQVRU$VVHPEO\

1. Turn the printer Off (O) and disconnect the AC power cord.

2. Open the media door and remove media and ribbon from the printer.

E-Ring

Bearing

Dancer

Torsion

Spring

Caution • This installation must be performed by a qualified service technician.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 167 168

Žádné komentáře

Zebra Z6M Specifikace Strana 101