Zebra 2746e Servisní příručka stáhnout pdf (Strana 41)

980428-117 Rev. 1 Prelim. 37

Installation

1. Slide the sensor guide's four (4) cables

through the sensor slide’s hole.

2. Insert and hook the label guide’s tab onto

the center panel’s cut-out.

3. Secure the label guide and sensor assembly

to the center panel with the pan head screw.

4. Close the printhead.

Hook guide to center panel

5. Re-connect the cables (JP27, JP28 and JP5)

to the Main PCBA. The five (5) conductor

cable exiting the bottom of the sensor slide

gets connected to JP5.

6. Re-tie the main PCBA harness. Use the

‘Securing the Wire Harness’ procedure,

980428-109, to properly re-attach the

cables.

3 conductor - JP27

2 conductor - JP28

(bottom set)

5 conductor - JP5

(bottom set)

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 85 86

Komentáře k této Příručce

Žádné komentáře