Zebra 105SL Plus Uživatelská příručka stáhnout pdf (Strana 22)

Introduction

Control Panel Display

P1056468-002 7/3/13

Set the Media Type

Select the type of media that you are using.

See Media Type on page 85 for more information.

Select the Media Sensor

Select the media sensor that is appropriate for the media that you

are using.

See Sensor Type on page 102 for more information.

Select the Print Method

Specify if ribbon is being used. Thermal Transfer media requires

ribbon for printing while Direct Thermal media does not.

To determine if you need to use ribbon, see When to Use Ribbon

on page 49.

See Print Method on page 85 for more information.

Adjust the Print Width

Specify the width of the labels being used.

See Print Width on page 85 for more information.

Set the Maximum Label Length

Set the maximum label length to a value that is at least 1.0 in.

(25.4 mm) greater than the actual label length plus the interlabel

gap. If you set the value to one that is smaller than the label length,

the printer assumes that continuous media is loaded, and the printer

cannot calibrate.

See Maximum Label Length on page 86 for more information.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 179 180

Žádné komentáře

Zebra 105SL Plus Uživatelská příručka Strana 22