Zebra T5206R Uživatelský manuál stáhnout pdf (Strana 279)

279

4 Downloading Software

Loading Flash Memory

Flash memory is contained in a SIMM (single in-line memory module) located

on the controller PCBA. Printer control languages (the “emulations”) and

printer operating system software are loaded into flash memory at the factory,

but there are occasions when you may have to download this software:

• You have replaced the controller PCBA

• You have replaced flash memory

• The customer needs to upgrade printer software

• The customer needs different emulation software

• The customer buys the PGL or VGL graphics language, the

CT option, the IPDS option, or the ethernet NIC (network interface card)

option after the printer is installed

Emulation and operating system software are included as files on a CD that

comes with the printer. You will copy the appropriate file from the

CD to a computer’s hard disk, then download the file from the computer into

printer memory.

IMPORTANT

When downloading emulation and operating system software to the

printer, all other optional fonts, customer-supplied logos, setup files,

feature files, and TIFF files will be erased. You will then need to reload

those files. Before starting a download procedure, be sure that you have

all the necessary files on hand.

You can download software through the serial, parallel, USB, or ethernet port

of the printer, and you can do it four ways:

• You can download software through any printer port except USB by using

the Firmware Download Utility included on the CD that comes with the

printer. (See page 280.)

• You can use a command prompt session to download software through

the parallel port. (See page 281.)

• If the printer has the NIC installed, you can download software through

the ethernet port. (See page 284.)

• You can use a command prompt session to download software through

the USB port. (See page 286.)

1 2 ... 274 275 276 277 278 279 280 281 282 283 284 ... 393 394

Žádné komentáře

Zebra T5206R Uživatelský manuál Strana 279