Zebra T5206R Uživatelský manuál Strana 107

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 394
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 106
QUICK SETUP Submenus
107
QUICK SETUP Submenus
Print Intensity
This option specifies the level of thermal energy from the printhead to be used
for the type of media and ribbon installed.
Large numbers imply more heat (thermal energy) to be applied for each dot.
This has a significant effect on print quality. The print intensity and speed
must match the media and ribbon type to obtain the best possible print quality
and barcode grades.
The range is from -15 to +15.
The factory default is -3.
Print Speed
This option specifies the speed in inches per second (ips) at which the media
passes through the printer while printing.
The range is from 1 to 10 ips (in increments of 1 ips).
The factory default is 6 ips.
NOTE: The maximum print speed varies based on maximum printer width
and dot per inch (dpi) resolution of the printhead installed (203 or
300 dpi). See Table 18 on page 345.
QUICK
SETUP
con’d
(from page 106)
SMT: Status
8
Disable*
Enable
PAA: Select
Tool
9
None*
CST-1
CST-2
.
.
.
.
Notes:
* = Factory Default
8
Appears only if RFID is installed and there is no CST bundle in the Flash File System.
9
Appears only if RFID is not installed and there is a CST bundle in the Flash File System.
Zobrazit stránku 106
1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 393 394

Komentáře k této Příručce

Žádné komentáře