Zebra Z6Mplus Uživatelská příručka stáhnout pdf (Strana 104)

Configuration

Control Panel LCD Displays

13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06

Print Server LCD Displays

The menu options shown in Table 10 display only if you have a print server installed.

Table 10 • Print Server Parameters (Page 1 of 5)

Parameter Action/Explanation

Load LAN Source

This parameter, which serves the same function as the ^NP ZPL command,

specifies whether to use the printer’s or the print server’s IP settings at

bootup.

Default: PRINTER

Selections: PRINTER, PRINTSERVER

To change the value shown:

1. Press SELECT to select the parameter.

2. Press PLUS (+) or MINUS (–) to toggle between the options.

3. Press

SELECT to accept any changes and deselect the parameter.

Check for Wired PrintServer

This parameter, which serves the same function as the ^NB ZPL command,

tells the printer whether to search for a wired print server at bootup.

Default: NO

Selections: YES, NO

To change the value shown:

1. Press SELECT to select the parameter.

2. Press PLUS (+) or MINUS (–) to toggle between the options.

3. Press

SELECT to accept any changes and deselect the parameter.

1 Appears only when the ZebraNet Wireless Print Server is installed.

2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the

print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to

address 192.168.254.254.

3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.

4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the

card supports LEAP.

LOAD LAN FROM?

PRINTER

WIRED PS CHECK?

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 165 166

Žádné komentáře

Zebra Z6Mplus Uživatelská příručka Strana 104