Zebra MP6000 Specifikace stáhnout pdf (Strana 170)

5 - 16 MP6000 INTEGRATOR GUIDE

Weighing Items

For proper weighing, items should be placed fully on the shaded (gray) regions of the scanner.

Figure 5-13

Gray Weighing Region

Long items may be weighed by laying them on the raise

d vegetable rail so that the end that overhangs the

weighing surface is suspended above the countertop.

To weigh items, follow the step

s below.

1. Ensure all items are removed from the platter, and the platter is in place.

2. Verify the Scale Display shows 0.00 lb (0.000 kg).

3. If weighing does not occur, press CLEAR on the POS and try entering the weighed item's PLU number

again. If an error code displays, or an error beep sounds, remove the item from the platter, remove the

platter and check for debris underneath. If there is debris, remove it. Replace the platter, and press the

Scale Zero button to reset the scale. Wait for 0.00 lb (0.000 kg) to display on the Scale Display and weigh

the item again.

Raised Rail

NOTE If the Scale Display does not show 0.00 lb (0.000 kg), clear all items off the platter and zero the scale by

touching the Scale Zero button.

After weighing an item, if tones are enabled, a sound emits indicating transmission of a stable, non–zero

weight.

NOTE If an error code displays in the 7-segment display, check Table A-1 on page A-5 for likely causes and

troubleshooting. If those suggestions do not help, take note of the error message and call your service

provider or help desk. See 7-segment Display on page 1-9 for the location of the 7-segment display.

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 209 210

Žádné komentáře

Zebra MP6000 Specifikace Strana 170