Zebra ZE500 Uživatelská příručka stáhnout pdf (Strana 148)

Applicator Interface Board Reconfiguration

Changing Jumper Settings for Isolated Mode

148

P1051584-002 8/23/12

5. On the back of the applicator interface board, remove the two mounting screws (1) that

secure the applicator interface board (

2) to the back plane of the print engine.

6. Locate the latch (1) on the side of the print engine.

7. Press the latch, and then swing the electronics enclosure open.

Note • For right-hand models, the latch is on the right side when you are facing the back

of the print engine. For left-hand models, the latch is on the left side.

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 169 170

Žádné komentáře

Zebra ZE500 Uživatelská příručka Strana 148