Zebra S-500 Uživatelská příručka Strana 12

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 80
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 11
Communications
The Stripe comes with either an Electronics Industries Association (EIA) RS-232 serial
data interface or a factory-installed parallel interface. In both cases, you must supply
the required interface cable for your application. See the Appendix for specific cable
requirements.
CAUTION: Zebra printers comply with FCC “Rules and Regulations”, Part 15, Subpart
J, for Class A Equipment, using fully shielded six-foot data cables. Use of longer cables
or unshielded cables may increase radiated emissions above the Class A limits.
Cutter Module Interface
(For Stripes with the Factory-Installed Cutter Option)
The Cutter Module connects to the printer via a standard 8-pin connector.
The cable on the front of the printer plugs into the connector on the bottom of the Cutter
Module once the Cutter Module has been installed.
Getting Started
4
Zobrazit stránku 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 79 80

Komentáře k této Příručce

Žádné komentáře