Zebra 105Se Specifikace stáhnout pdf (Strana 18)

10 Zebra S-Series User’s Guide

9$&2SHUDWLRQ

1. Confirm that the voltage selector switch is set to 115 V.

2. Attach the supplied power cord to the AC power receptacle located on

the rear of the printer.

3. Connect the opposite end of the power cord to a properly grounded

source of 115 VAC (50 or 60 Hz) power rated for at least 5 Amps.

9$&2SHUDWLRQ

1. Confirm that the voltage selector switch is set to 230 V.

2. Depending on how the printer was ordered, a power cord may or may

not be provided for 230 VAC operation. If not provided, obtain a cord

set with the proper AC power plug. The cord may then be connected

to the standard (international) IEC-type 3-prong AC connector

provided on the S-Series Printer. Refer to “230 VAC Power Cord” on

page 83 for more information.

6LWH5HTXLUHPHQWV

&$87,217RHQVXUHWKDWWKH66HULHV3ULQWHUKDVSURSHU

YHQWLODWLRQDQGFRROLQJGRQRWSODFHDQ\SDGGLQJRUFXVKLRQLQJ

PDWHULDORQWKHEDFNRIRUXQGHUQHDWKWKHXQLWDVWKLVUHVWULFWVWKH

DLUIORZ

The S-Series Printer may be installed on any solid, level surface of

sufficient size and strength to accommodate the unit. The area in which

the printer operates must meet the environmental conditions specified (see

page 77).

Since the Zebra S-Series Printer was designed and is fabricated as an

industrial-type unit, it functions satisfactorily in areas such as a warehouse

or factory floor that conform to the specified environmental and electrical

conditions (see page 76).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 109 110

Žádné komentáře

Zebra 105Se Specifikace Strana 18